Set top of page at current position
Model ASCII
Decimal
Hexadecimal
I
IBM 1 <ESC>
“4” 27 52 IlB 34
I
Sets the current position as the top-of-page position. Note that this can
also be done from the control panel.
Set page length to n lines
Mode
ASCII
Decimal
Hexadecimal
Both <ESC>
“C” n
27 67 n
1B 43 n
Sets the page length ton lines in the current line spacing, where n is between
1 and 127 in Standard mode or between 1 and 255 in IBM mode. Changing
the line spacing later does not alter the physical page length. The current
line becomes the top of the page.
Set page length to n inches
IModel ASCII I
Decimal
I
Hexadecimal I
I
Both <ESC> “C” CO> n 27 67 0 n 1B 43 00 n
Sets the page length to n inches, where n is between 1 and 22 in Standard
mode or between 1 and 127 in IBM mode. The current line becomes the
top of the page.
Set top margin
ASCII
< ESC > “c” n
Decimal
I 27 99 n
Hexadecimal
IlB 63 n
Sets the top margin to (n - 1) lines, where n is between 1 and 255. Printing
begins on the nth line on the page. The power-up default is n = 1, giving
no top margin.
Set bottom margin
Mode
ASCII
Decimal Hexadecimal
Both 1 <ESC>
“IV n 1 27 78 n
IlB 4E n
Sets the bottom margin to n lines, where n is between 0 and 127 in Standard
mode or between 0 and 255 in IBM mode. The bottom margin is reset
when you change the page length.
To Next Page
Loading...
