– 20 –
2. Lubrication
Lubrication is very important to maintain optimum performance and to prevent trouble.
2-1. Lubricant
The type of lubricant greatly affects the performance and durability of the printer, especially in a low temperature
environment. We recommend use of the grease and lubrication oils listed below for this printer.
Type of oil Product name Maker
Grease Molykote EM-30L Dow Corning Corporation
Lubricant Mobil 1 Mobil Oil Co., Ltd.
2-2. Lubricating Method
When lubrication is carried out in assembly and disassembly, wash parts well to remove dust and dirt before lubrication.
Lubrication must be carried out regularly once every 6 months or after 1 million lines have been printed. Lubrication is
necessary irrespective of the regular lubrication whenever lubricant becomes deficient after cleaning or whenever parts
have been disassembled or replaced.
2-3. Lubricated Areas
NO. Lubricating Point Grease/Oil
1 Rubbing surfaces of Carriage unit and Carriage guide EM-30L
2 Rubbing surfaces of Ribbon shaft unit and Ribbon base EM-30L
3 Rubbing surfaces of Ribbon shaft unit and Worm gear EM-30L
4 Rubbing surfaces of Ribbon shaft unit and Back stop spring EM-30L
5 Rubbing surfaces of Ribbon shaft unit and Frame EM-30L
6 Rubbing surfaces of Worm gear and Frame EM-30L
7 Drive shaft grooves EM-30L
8 Rubbing surfaces of Gear 16 × 53 × 0.4 and Frame EM-30L
9 Rubbing surfaces of Worm wheel and Ribbon shaft EM-30L
0 Rubbing surfaces of Paper feed roller and Paper guide B EM-30L
A Rubbing surfaces of Paper feed roller and Paper guide A EM-30L
B Rubbing surfaces of Paper guide A and gear 16 × 53 × 0.4 EM-30L
C Rubbing surfaces of Holder roller and Holder roller spring EM-30L
D Rubbing surfaces of Carriage unit and Carriage stay Mobil 1
3. Screw Locking
Screw sealant is applied to parts so that the screws in the printer will not come loose from vibration during shipment.
When carrying out replacement of parts, apply sealant to the following screws, in accordance with Fig. 3-3.
NO. Locking Point Locking Agent
a Joining pointing of Screw-head and Print head ThreeBond 1400B
b Joining pointing of Carriage boss and Ribbon separator hole ThreeBond 1400B
c Joining pointing of Adjusting bushing and Frame L Cemedine X No.8008
d Joining pointing of Adjusting bushing and Frame L Cemedine X No.8008
e Joining pointing of Platen and Screws Cemedine X No.8008
To Next Page
Loading...
