– 19 –
(3) Pull on the edge of the paper to
remove any slack and then push
down both sides of the printer cover
to close.
Note: Make sure that the printer
cover is securely closed.
(4) If the printer cover is closed after
turning on the power, the cutter op-
erates automatically and the front
end of the paper is cut.
Note: If the cutter does not operate
after the printer cover is
closed, open the cover and
close it again securely.
(5) If necessary, attach the paper stop-
per to the paper cover as shown
below. The output tray can hold up
to 30 sheets (thickness: 80–105 µm,
length: 50–150 mm).
Note: When attaching the paper
stopper to the paper cover,
position the stopper accord-
ing to the length of the cut
paper. (Refer to the follow-
ing table.)
Paper length (mm)
Position 1 50 – 100
Position 2 100 – 120
Position 3 120 – 140
Position 4 140 – 160
Position 5 160 – 180
Position 6 180 – 200
Position 1
Position 2
Position 3
Position 4
Position 5
Position 6
To Next Page
Loading...
