– 24 –
8-3. Releasing a Locked Cutter
If the auto cutter locks up or fails to cut the paper, follow the steps below.
Caution
Since working on the cutter may be dangerous, be sure to turn off the printer first.
(1) Set the power switch to OFF to turn off the printer.
(2) Slide off the front cover to reveal the auto cutter.
(3) Remove any jammed paper.
Note: Be careful not to damage the printer while removing any jammed
paper.
Since the thermal print head is particularly sensitive, be sure not to
touch it.
Front cover
Tab
To Next Page
Loading...
