– 35 –
No. 1
DIP-SW1
2 3 4 5 6 7 8
No. 1
DIP-SW2
2 3 4
B-3. USB Interface Model
ON ON
OFF OFF
Switch
Function ON OFF
1-1 Command emulation
See table below
1-2 Command emulation
1-3 Should not be changed (Should be set to on)
1-4 Sensor adjustment Valid Invalid
1-5 USB mode See table below
1-6 Handshaking conditions Offine or receive Receive buffer full
(conditions for BUSY) buffer fuu
1-7 Automatic status back function Invalid Valid
1-8 Should not be changed (Should be set to on)
The factory settings of DIP switch are all on.
Switch 1-5 USB Mode
ON Mode 1 (Printer class)
OFF Mode 2 (Vendor class)
DIP-SW1
Note:
1) A STAR USB Printer Driver Set is needed for using the USB interface on
Windows 98 or 98SE . You can download the STAR USB Printer Driver
Set from the following website.
2) Download the Mode 2 (vendor class) driver set from the following
website for use.
Printer Driver URL http://www.star-m.jp/eng/dl/dl02.htm
DIP-SW 2
Switch
Function ON OFF
2-1~2-4 Always ON Should be set to on
The factory settings of DIP switch are all on.
Switch 1-1 Switch 1-2 Command emulation
ON ON Star Line Mode
OFF ON Star page Mode
OFF OFF ESC/POS Mode
To Next Page
Loading...
