– 36 –
No. 1
DIP-SW1
2 3 4 5 6 7 8
No. 1
DIP-SW2
2 3 4
B-4. Ethernet Interface Model
ON ON
OFF OFF
Switch
Function ON OFF
1-1 Command emulation
See table below
1-2 Command emulation
1-3 Should not be changed (Should be set to on)
1-4 Sensor adjustment Valid Invalid
1-5 Should not be changed (Should be set to on)
1-6 Handshaking coditions Offline or receive Receive buffer full
(conditions for BUSY) buffer full
1-7 Should not be changed (Should be set to on)
1-8 Should not be changed (Should be set to on)
The factory settings of DIP switch are all on.
DIP-SW 2
Switch
Function ON OFF
2-1~2-4 Always ON Should be set to on
The factory settings of DIP switch are all on.
DIP-SW1
Switch 1-1 Switch 1-2 Command emulation
ON ON Star Line Mode
OFF ON Star Page Mode
OFF OFF ESC/POS Mode
To Next Page
Loading...
