Software Manual
13
(7) Uncheck "Dynamic (DHCP)", enter the IP address, subnet mask, and default gateway, and then
click [Apply].
Ask your network administrator about the static IP address and subnet mask to
use in the settings.
・If you enable “Multi Session”, it will be possible for terminals to get status from the printer
even when multiple terminals are connected simultaneously.
・If “Disconnect Message” is set to Enable, "NO HOST CONNECTION" will be printed when
the printer has been disconnected. This function is available in firmware version 110.110.100 or
later of the printer.
・ If you click Initialize, all settings (including the password setting) return to their factory
defaults.
・ It is possible to set a fixed IP address from another segment. If you do so, however, the printer
will no longer be locatable by the Ethernet Setup Tool's LAN search.
To Next Page
Loading...