Software Manual
12
(5) If the "Windows Security Alert" screen is displayed, click [Allow access].
Notes: If you click [Cancel], you will not be able to search for the LAN printer.
(6) The TSP100 LAN / Bluetooth Setup Tool screen is displayed.
If the printer you want to install is not listed in the LAN printer list, click [Discovery].
The factory network settings of the TSP100IIIW printer are as follows.
Network Mode: Ad-Hoc *
IP address: 0.0.0.0 (Unassigned)
Subnet mask: 0.0.0.0 (Unassigned)
Default gateway: 0.0.0.0 (Unassigned)
Use DHCP: ENABLE (Selected)
* The printer automatically enters the infrastructure mode when it connects over WPS.
To Next Page
Loading...
