Software Manual
16
(10) From the menu displayed on the left side of the setting screen or the menu button displayed on the
upper left, open [IP Parameters] , select “Static” and enter the IP Address, Subnet Mask, and tap
[Submit].
Ask your network administrator about the static IP address and subnet mask to use in
the settings.
(11) From the menu of the menu button on the upper left, open [Save], select "Save"→"Configuration
Printing"→"Restart device", and tap [Execute].
The settings are saved to the printer and printed out.
(12) The settings are saved to the printer and printed out. Then proceed to
Section 1.3.2, "Creating a
Printer Queue."
Note: After the printer reset, it may take a short time (perhaps 20 seconds) for the printer to be
found again.
If the printer fails to reappear on the printer list after a noticeable amount of time has
passed, retry the search by clicking again on the [Discovery] button.
To Next Page
Loading...
