Star Micronics TSP400 Series - Adjusting the Head Position

– 3 –
ENGLISH
Thick paper
Thin paper
0.6mm
9 Return the print head unit to its
original position and be sure that it
locks into place. (The printer cover
will not close unless the print head
unit is locked.)
0 Move the paper roll onto the print-
er’s paper-roll holder.
A Hold the roll down and pull on the
leading edge of the paper to re-
move any slack.
B Close the printer cover.
1-2. Adjusting the Head Position
Fig. 1-7
1 You can set the print head position
to accommodate thick or thin paper.
Change the position by moving the
left-side and right-side levers for-
ward or back.
2 Be sure to unlock the print head
before moving the levers.
Fig. 1-8