Star Micronics TSP600 Series - Page 38

– 35 –
LINE MODE
Commands to Control Peripheral Devices
FUNCTION
Define drive pulse width for peripheral device
CODE
<ESC><BEL> n1 n2
HEX
1B 07 n1 n2
REMARKS
Defines the drive pulse width for peripheral devices requiring
other than standard 200 ms pulse time and delay time.
n1 indicates the energizing time and n2 indicates the delay time,
using 10ms units.
The values of n1, n2 are 1 to 127.
FUNCTION
Control peripheral device #1
CODE
<BEL>
HEX
07
REMARKS
Executes drive pulse for peripheral device #1.
FUNCTION
Control peripheral device #1
CODE
<FS>
HEX
1C
REMARKS
Executes drive pulse for peripheral device #1.
FUNCTION
Control peripheral device #2
CODE
<EM>
HEX
19
REMARKS
Drives peripheral device #2. The drive pulse width and delay time
are fixed at 200 ms.
FUNCTION
Control peripheral device #2
CODE
<SUB>
HEX
1A
REMARKS
Drives peripheral device #2. The drive pulse width and delay time
are fixed at 200 ms.