Star Micronics TSP600 Series - Page 39

– 36 –
LINE MODE
Commands to Control Auto Cutter
FUNCTION
Cut command to the auto cutter
CODE
<ESC> “d” n
HEX
1B 64 n
REMARKS
n = “0” or <0> : TSP700/800
Cuts the paper fully immediately.
n = “1” or <1> : TSP600/700/800
Cuts the paper leaving one point uncut immedi-
ately.
n = “2” or <2> : TSP700/800
Cuts the paper fully after feeding the paper to
the cutting position.
When print start position detect is ON, feeds the
paper to the next print start position first, feeds
the paper to the cutting position, then cuts the
paper fully.
n = “3” or <3> : TSP600/700/800
Cuts the paper fully after feeding the paper to
the cutting position.
When print start position detect is ON, feeds the
paper to the next print start position first, feeds
the paper to the cutting position, then cuts the
paper leaving one point uncut.
FUNCTION
Feed to the tear bar position (TSP600 only)
CODE
<ESC> “d”“t”
HEX
1B 64 74
REMARKS
Feeds the paper to the tear bar position.