– 59 –
PAGE MODE
Other commands
FUNCTION
Print Label
CODE
<ESC> “I” <LF><NUL>
HEX
1B 49 0A 00
REMARKS
This command prints out one label according to the previously
defined format and data.
When print start position detect is ON, the paper will be fed to the
next print start position after printing.
If unrecoverable error occurs during printing, a series of these
operation will be repeated after the printer recovers from the error
condition.
FUNCTION
Print Label
CODE
<ESC> “W s1s2s3s4 , h1h2h3h4” <LF> <NUL>
HEX
1B 57 s1s2s3s4 2C h1h2h3h4 0A 00
REMARKS
This command prints out the data within the defined print area.
Print area defined by <ESC>“D” is ignored.
When print start position detect is ON, the paper will be fed to the
next print start position after printing.
If unrecoverable error occurs during printing, a series of these
operation will be repeated after the printer recovers from the error
condition.
s1s2s3s4 : Print start position in the Y direction (unit: 0.1 mm)
h1h2h3h4: Print length from the print start position (unit: 0.1
mm)
To Next Page
Loading...
