– 60 –
PAGE MODE
FUNCTION
Enable cutter
CODE
<ESC> “B d n1n2” <LF><NUL>
HEX
1B 42 d n1n2 0A 00
REMARKS
This command defines cut position and enables cutter. This
command does not energize cutter.
Cutter will be operated only when receiving<ESC> “I” com-
mand.
d :“+” or “-” indicates the direction of the cut position
from the normal position.
“+” indicates a forward feed, and “-” indicates a
reverse feed from the normal cut position.
n1n2 : Indicates the value to move in 1/10 mm unit.(00 to 50)
Note: a) If these parameters (d and n1n2) are omitted, then the
cut position is set at the default position.
b) Default cut position , or normal position, is at the
bottom edge of the print area.
c) d:“@” means that cutting operation is omitted one
time. In this case, n1n2 is not specified.
FUNCTION
Set Memory Switch
CODE
<ESC> “# N , n1n2n3n4”<LF> <NUL>
HEX
1B 23 N 2C n1n2n3n4 0A 00
REMARKS
Set the memory switch. In order to enable changed memory switch
settings, turn the printer OFF and ON again or send printer reset
command (<ESC>“?”) to the printer. Changed memory switch
settings are stored in EEPROM and these setting will be stored as
long as the time when they are changed again.
N :Memory switch number (1 only)
n1n2n3n4 :Mode settings (For details see below)
1) Use N=1 to set printer conditions. Parameters are as follows.
n1 :Always “0”
n2 :Start-position detect
n3 :Zero style
n4 :International character set
To Next Page
Loading...
