Star Micronics TSP600 Series - Page 85

– 82 –
APPENDIX
EXAMPLE Bar code string number 10, starting position of bar code (X, Y)
= 5 mm, 10 mm, use Mode 1 of EAN-13, Bar code height 10 mm
data:246801357956, bar code rotation direction 0 degree
LPRINT CHR$(&H1B);“PB10;0050,0100,1,6,0,0100”;
CHR$(&H0A);CHR$(&H00);
LPRINT CHR$(&H1B);“RB10;246801357956”;
CHR$(&H0A);CHR$(&H00);
(7) CODE 128
This code can represent 128 ASCII characters.
1) Each mode and module width
a) Horizontal printing Note: The start and stop bars are not included.
Item
Module width
Width of one
character
Mode 1 Mode 2 Mode 3
2 dots 3 dots 4 dots
2.75 mm 4.125 mm 5.5 mm
Item
Module width
Width of one
character
Mode 1 Mode 2 Mode 3
2 dots 3 dots 4 dots
3.125 mm 4.5 mm 6.5 mm
b) Vertical printing
2) REQUIREMENTS
%(25 H) is sent as data %0(25H 35H). Control codes 00H to 1FH and 7FH are
sent as data % followed by 40H to 5FH and 35 H. For example, control code 7FH
is sent as data %5 (25H 35H). Function codes are sent as data % followed by 1
to 4 (31H to 34H). The start code is sent as data % followed by 6 to 8(36H to 38H).
Although CODE 128 data requires START CODE, the printer automatically adds
START CODE. Please omit START CODE when sending data to the printer.