– 32 –
LINE MODE
FUNCTION
Print logo image
CODE
<ESC> <FS> “p” nm
HEX
1B 1C 70 nm
REMARKS
Prints the logo image n using the mode specified by m.
n 1
n 255
Logo image number defined by the command <ESC> <FS>
“q” is specified.
m 0 m 3 or “0” m “3”
m = 0 or “0” Normal
m = 1 or “1” Double-width
m = 2 or “2” Double-height
m = 3 or “3” Quadruple ( double-width, double height )
Note) If there is unprinted data in the line buffer, this command will be
executed after the data in the line buffer is printed out.
This command is not affected by print modes (emphasized, under-
line, character size, etc.) except inverted printing.
Print start position in the horizontal direction is the left margin
position. Horizontal print area follows the left and right margin
settings.
If the horizontal size of the logo image exceeds the horizontal print
area, the exceeded data is not printed.
To Next Page
Loading...
