– 37 –
LINE MODE
Other Commands
FUNCTION
Cancel last line & Initialize printer
CODE
<CAN>
HEX
18
REMARKS
Clears the line buffer, and initializes the commands set already.
Does not affect the external equipment drive conditions set by the
code <ESC> <BEL> n1 n2. (This is the same during a mechanical
error.)
FUNCTION
Set memory switch
CODE
<ESC> “# N , n1n2n3n4” <LF> <NUL>
HEX
1B 23 N 2C n1n2n3n4 0A 00
REMARKS
Set the memory switch. In order to enable changed memory switch
setting, turn the printer OFF and ON again or send printer reset
command (<ESC> “?”) to the printer. Changed memory switch
settings are stored in EEPROM and these setting will be stored as
long as the time when they are changed again.
N :Memory switch number (1 or 3)
n1n2n3n4 :Mode settings (For details see below)
1) Use N=1 to set printer conditions. Parameters are follows.
n1 :Always “0”
n2 :Start-position detect
n3 :Zero style
n4 :International character set
Parammeter
n1
n2
n3
n4
Setting
Always “0”
Start-position delect
Zero style
International character set
(Default)
0
-
OFF
Normal zero
1
-
ON
Slashed zero
See below
n4 Country
0 USA
1 France
2 Germany
n4 Country
3UK
4 Denmark #1
5 Sweden
n4 Country
6 Itary
7 Spain #1
8 Japan
n4 Country
9 Norway
A Denmark #2
B Spain #2
n4 Country
C Latin America
D Korea
E Ireland
F Legal
To Next Page
Loading...
