Star Micronics TSP700 Series - Page 32

13-1
13 OPERATION PANEL AND FUNCTIONS
13.1 Operation Panel
13.1.1 POWER LED (Green)
Normally lights when printer power is turned on.
Combined with the ERROR LED, the printer status can be ascertained.
13.1.2 ERROR LED (Red)
Combined with the POWER LED, the printer status can be ascertained.
13.1.3 FEED Switch
Feeds paper when pressed. (Feeds to the top of form when that function is enabled.)
13.2 LED Display
ONLINE Status
POWER LED ERROR LED Cause Recovery
Head High Temp.
Detected (Print
Stopped)
Flashes (every
0.5 seconds)
Extinguished Head is very hot. Automatic recovery
when the head
temperature drops
Near-end Detection Lit Flashes (every
2 seconds)
Not enough paper Replace the paper
Error Status (OFFLINE, Recoverable)
POWER LED ERROR LED Cause Recovery
Cover Open Error Lit Lit Cover is open. Close the cover.
No Paper Error Lit Flashes (every
1/2 second)
No paper Set the paper
Error Status (OFFLINE, Non-recoverable)
POWER LED ERROR LED Cause Recovery
Auto-cutter Error Extinguished Flashes (every
1/8 second)
Cutter operating
improperly
Check/repair the
cutter
RAM Error Extinguished Lit RAM Access
Problem
Repair
Flash Error Flashes (every
1/4 second)
Flashes (every
1/4 second)
Flash Access
Problem
Repair
Thermistor Error Flashes (every
1/2 second)
Flashes (every
1/2 second)
Erroneous Value for
the Head
Thermistor Resistor
Repair
Power Voltage
Errors
Flashes (every
1 seconds)
Flashes (every
1 second)
Erroneous Value
for the Power
Voltage
Check/repair the
power