Star Micronics TSP700 Series - Page 39

14-3
14.2.2 ESC/POS Mode
When using a parallel interface, all settings other than 1-1 are ON at ex-factory.
Switches Content ON OFF
1-1
Emulation Fixed at OFF
1-2 Basic Calculated Pitch
Offset
203 DPI (EPSON
Compatible)
180DPI
1-3
Always ON Always used as ON
1-4
Sensor Adjustment Mode Disabled Enabled
1-5 Reset by INIT Signal
Enabled Disabled
1-6 BUSY Condition
Reception Buffer Full
OFFLINE
Reception Buffer Full
1-7
ASB Function Disabled Enabled
1-8
Always ON Always used as ON
When using a serial interface, all settings other than 1-1 are ON at ex-factory.
Switches Content ON OFF
1-1
Emulation Fixed at OFF
1-2 Basic Calculated Pitch
Offset
203 DPI (EPSON
Compatible)
180DPI
1-3
Always ON Always used as ON
1-4
Sensor Adjustment Mode Disabled Enabled
1-5
Always ON Always used as ON
1-6 BUSY Condition
Reception Buffer Full
OFFLINE
Reception Buffer Full
1-7
ASB Function Disabled Enabled
1-8
Always ON Always used as ON
When using a USB/Network Interface
ESC/POS Mode cannot be selected. When the DIP switch 1-1 is turned OFF, the printer enters the
STAR Line mode.