Star Micronics TSP700 Series - Page 46

15-5
15.3.3 Memory Switch 2 (MSW2)
Bit Function 0 1 STAR ESC/POS Note
F
E
D
C
B
A
9
8
7
6
5 Print Speed (See Table Below) ○ ○
*2
4 Print Speed (See Table Below) ○ ○ *2
3
2 Print Density (See Table Below) ○ ○
*3
1 Print Density (See Table Below) ○ ○ *3
0 Print Density (See Table Below) ○ ○ *3
[*2] • MSW2-5,4 Print Speed Details
N3 MSW2-5 MSW 2-4 Print Speed
“0” 0 0 Standard
“1” 0 1 Mid-speed
“2” 1 0 Low Speed
• When two-color printing mode is selected, this setting is disabled (the printer is fixed to 75 mm/sec).
• ESC/POS mode raster graphics printing is not dependent upon this print speed setting. Raster
graphics print speed is specified by MSWD-0, 1.
[*3] • MSW2-2 to 0 Print Density Details
N4 MSW2-2 MSW 2-1 MSW2-0 Print Density Print Density
(2-Color Print Mode)
“0” 0 0 0 1.0 1.0
“1” 0 0 1 1.1 1.0
“2” 0 1 0 1.2 1.2
“3” 0 1 1 1.3 1.2
“4” 1 0 0 1.0 1.0
“5” 1 0 1 0.9 1.0
“6” 1 1 0 0.8 0.8
“7” 1 1 1 0.7 0.8