Star Micronics TSP743II Series - Page 16

3-6-3. Changing the Adjustment Lever Position
e adjustment lever position must be changed in accordance with the paper thickness. It is factory-set to position 1.
When using paper thickness between 100 and 150 μm, change the adjustment lever position in accordance with the
procedure below.
As shown, use a at head screwdriver to move the adjustment lever inward. en,
lower the adjustment lever to the position in which the protrusion on the adjust-
ment lever engages with the hole in the frame.
Note: Do not use position 2.
Position 3
Paper thickness
between 105 μm and 150 μm
Position 1
Paper thickness
between 65 μm and 105 μm
3-6-4. Removing the Roll Paper Guide
When using a paper roll with an 82.5 mm width, remove the roll paper guide as shown.
When using a paper roll with a 57.5 mm width, remove the roll paper guide, and install the roll paper guide into the other
groove. When you change the eective print width (paper roll width), change the printer utility’s memory switch setting.
For details, see the printer utility help.
Note: Aer using a paper roll with a width of 57.5 mm, do not change to a paper roll with a width of 79.5 or 82.5
mm. is is because the printer head has deteriorated as a result of a portion of the head having been in
direct contact with the platen.
-
16
-
Roll paper guide