Star Micronics TUP500 series - Page 119

TUP500 Series Product Specifications 15-2
When Power is ON
Operating Mode Mode Entering Conditions Operation
SW1 SW2 Cover DIPSW1 Setting
1 2 3 4 5 6 7 8 9 10
Self-test Print Push -- -- * * * ON * * * * * * Self-print → Printer Reset
Hex Dump -- Push -- * * * ON * * * * * * Enters Hex Dump Mode
Sensor Adjustment Mode
・PE/BM Sensor
-- -- Closed * * * OFF ON * * * * * LED Flashes, and printer
enters the sensor adjustment
mode
Sensor Adjustment Mode
・NE Sensor
-- Push Closed * * * OFF ON * * * * * LED Flashes, and printer
enters the sensor adjustment
mode
Sensor Adjustment Mode
・ Presenter Sensor 1
Push -- Closed * * * OFF ON * * * * * With LED ashing:
Enters Sensor Adjustment
Mode
When Online
Operating Operation Memo
SW1 SW2
Push -- Paper Feed (*1)
Push
(2 Sec.)
Push
(2 Sec.)
Executes printer reset. After pushing SW2, input SW1.
(*1) Paper Feed
Presenter Status Black Mark Function Paper Feed Specications
Non-contact Invalid Paper is fed while SW1 is pressed.
Valid BM detection operation + full cut
Contact Invalid Paper Feed + Full Cut + Presenter Paper Discharge
Valid BM Detection + Full Cut + Presenter Paper Discharge
When errors occur
Operating Operation Memo
SW1 SW2
-- Push Error cancel operation The predetermined error cancelation operation was performed.
Push -- Paper is discharged from printer. If there is no paper and printing has stopped because of the error, it is possible to discharge
the paper remaining in the printer without opening the cover.
However, this function can damage the print head so do not over use it.
Push
(2 Secs.)
Push
(2 Secs.)
Executes printer reset. After pushing SW2, push SW1.