TUP500 Series Product Specifications 3-12
9) Pre-printing Range on the Backside of Paper See table below.
When pre-printing to the backside of recording paper, it should meet the following specifications.
Notes:
1. When using paper used to pre-print, adequately check operations on the actual layout and
print media.
2. If out of the above specifications, the paper detector (sensor) may mis-detect paper, or not
detect at all.
3. When using thermal paper implemented with pre-printing, always evaluate on the actual
machine, before use.
(10) Effective Paper Width: The effective print width adjustment can be made by setting
memory switch. The representative paper widths are outlined below.
Paper Width (mm) Left/Right Margins Effective Print Width
45±0.5 4 mm per side: Total 8 mm 37mm
57.5±0.5 4 mm per side: Total 8 mm 50mm
79.5±0.5 4 mm per side: Total 8 mm 72mm
82.5±0.5
4 mm per side: Total 8 mm 74mm
1.25mm per side: Total 2.5 mm 80mm *
P rint D irectio n
C enter of Paper W idth
B a cksid e of Paper
No Preprinting
(TUP592)
B a cksid e of Paper
No Preprinting
(TUP542)
9m m
Fig . 3.3.1 .12 P reprinting Range
-
From Paper Edge
Min. 15 mm
To Next Page
Loading...
