Star SM-L200 SERIES - Page 29

20
Example
When you want to change the settings of the printer mode as shown below,
Item Factory Setting Configuration Example
1 Density 0(Medium) 1(Low)
2 Standby Time 0060(Sec) 0080(Sec)
3 Auto Off Time 0000(Invalid) 1000(Min)
4 Smart Power 0(Disable) 0(Disable)
5 Paper Type 0(Receipt) 2(BM(Back))
6 Factory Reset 0(Cancel) 0(Cancel)
7 Password 0000 2222
8 Previous Menu --- ---
Press and hold the MODE & FEED buttons for 5 seconds.
→You will see present “Enter Menu Mode” in the OLED.
Press the MODE button once to switch the menu item.
Display: 1 Self Test →2 System Setting
Press the FEED button once to get into the System Setting menu.
→You will see present “Input Password 0000” in the OLED.
→Press FEED button to move cursor(“_”),Press MODE button to switch the number (0~9).
Password: 0000(default)
→Press and hold the FEED button for 2 seconds to get into the menu.
Display: 1 Density
2 Standby Time
3 Auto off Time
4 Smart Power
[Density]
Press MODE button to switch the menu item,then press the FEED button once to enter the menu.
→Press the FEED button once to get into the Density menu.
Display: Density:
0-Medium 1-Low
2-High 0
3-Special