Display: 1 Self Test
2 System Setting
3 Exit Menu
[Self Test]
Press the MODE button 2 times to switch the menu item--Self Test.
Press the FEED button once to enter the menu item--Self Test.
Display: 1 Print
2 MSR
3 MSR Key Inject
4 Hex Dump Mode
5 Previous Menu
→Press the FEED button once,you will see present “Press Feed To Print” in the OLED, press FEED button, the
new settings will be printed.
If the settings were not configured correctly, follow the above procedure to configure the settings again.
To Next Page
Loading...
