Available DIP switch settings
The following table shows all the possible settings for the DIP switch. The
factory default settings are ON for switches 1 through 7 and OFF for switches
8 through 10.
Switch Parameter ON OFF
1
Baud Rate See table below
2
3 Data Length 8 bits 7 bits
4 Parity Check Disabled Enabled
5 Parity Odd Even
6 Handshake DTR/DSR XON/XOFF
7 Receive Buffer Size
STAR: 2K bytes
ESC/POS: 512 bytes
35 bytes
8 Command Emulation STAR ESC/POS
9 Pin 6 (DSR) Reset Signal Enabled Disabled
10 Pin 25 (INIT) Reset Signal Enabled Disabled
Baud Rate Switch 1 Switch 2
1200BPS OFF OFF
2400BPS OFF ON
4800BPS ON OFF
9600BPS ON ON
To Next Page
Loading...
