MAINTENANCE
17
Uninsulated terminal poles on the accumulator should be protected with an insulated cover. When connecting
the accumulator and socket, make sure to stop the device and put the switch at position “0”. When replace or
install the accumulator, make sure the accumulator is xed securely in battery box.
STORAGE, TRANSPORTATION, AND INSTALLATION OF THE ACCUMULATOR
The device must be parked on the level ground steadily. To prevent short circuit, naked cable ends, and the
terminal posts should be covered with insulated covers. When pulling out the accumulator, properly arrange
removed accumulator’s connectors and cables without blocking access of the accumulator.
BATTERY POWER INDICATOR
Battery power display table: ten articles showing represent 100% of the battery.
With the consumption of battery capacity, the glowing article shows will be from top to down.
The color of LED show the dierent states:
Battery discharge on 70%, red lamp will be
blinking “Energy storage”.
Battery discharge on 80%, two lamps will
blinking “out of battery”, this indicates you
need to charge the accumulator.
CHARGING
Read the instruction manual carefully before recharging.
a) Must use Li-ion Charger specially designed by our company
b) Do not reverse charge the battery
c) Stop charging immediately when battery has obvious heat
during charging. Then cool it before charging
d) Please hold the handle when pulling charger connector,
direct drawing of wire is not allowed
DISASSEMBLY AND INSTALLATION OF BATTERY
Parking the truck before the battery is removed and installed
Disassembly & Installation battery step:
A) Turn o
the car
B) Pull the power connector handle and unplug the power
connector(Attention: When pulling the power connector, Must
hold the handle. Please do not pull the wire directly
C) Pull up the battery and pull the battery out of the car
D) Insert the new battery into the battery mounting slot
To Next Page
Loading...
General