Set up and Programming
When the camera is first turned on, the internal LCD screen displays
the camera status. The following information is present on this screen.
Flash Mode Control:
The camera is pre-programmed with Auto Flash setting.
Switch the camera to ON position.
To turn off the flash mode, press the [UP] button once
within 30 seconds. icon will appear in the status screen.
To turn the flash mode back to Auto setting, press the [UP]
button the second time. icon will appear on the top of the
screen.
If no buttons are pressed after 30 seconds, the LCD screen will
power down to conserve battery life and enter 1 minute count
down to enter PIR detection mode. To re-power the display
screen, press and hold the UP or DOWN button until you see the
status screen.
To Next Page
Loading...
Need help?
General
