Steam Planet MG-305 - User Manual

Questions and Answers

P
piercerandallAug 11, 2025
Why is the pump not working on my Steam Planet Hot Tub?
- T
  Tina SparksAug 11, 2025
  If the pump on your Steam Planet Hot Tub isn't working, first ensure the power plug is fully plugged in. Then, check if the Residual Current Protective device is off; if so, find and remove any short circuits before reconnecting the protection switch. Also, the impeller might be blocked, so clean it. Ensure the pump is switched on and that there is power by checking the wiring. If none of these steps work, the pump may be broken and need replacing. Lastly, check the connection between the air pipe and air switch, reconnecting if necessary.
R
Robert WadeAug 18, 2025
What to do if the water jet strength is not adjusting on my Steam Planet MG-305?
- K
  Kenneth WiseAug 18, 2025
  If the water jet strength on your Steam Planet Hot Tub isn't adjusting, start by checking the voltage and use a suitable transformer if it's abnormal. Next, ensure the air switch is on and charged if necessary. Also, check the suctions and clean them, if they are stopped.
D
Denise CarterAug 27, 2025
How to level a Steam Planet MG-305 Hot Tub?
- B
  Billy RomeroAug 27, 2025
  If your Steam Planet Hot Tub isn't leveled, it's likely due to the leveling feet not being properly adjusted. Make sure to adjust the leveling feet until the hot tub is stable and even.
Q
qhartSep 3, 2025
What to do if the water pipe leaks in Steam Planet MG-305 Hot Tub?
- J
  Jason SheppardSep 3, 2025
  If you notice a water pipe leaking in your Steam Planet Hot Tub, it could be due to a poor seal ring, a poorly connected nut, or a poor joint connection. Try reinstalling or changing the seal ring first. If that doesn't work, tighten the nut. For a poor joint connection, reconnect the joint and apply silicon.

Steam Planet MG-305 Specifications

General

Brand	Steam Planet
Model	MG-305
Category	Hot Tub
Language	English