Steba IC 30 - Assembly and Operation; Component Identification; Assembly and Setup Steps; Setting the Timer

42 pages

To Next Page

To Previous Page

Assembling and operation

1) Motor 2) Lid

3) Rabble arm 4) Freeze container

5) Housing 6) Setting button

7) Start/Stop button

Click the motor part into place to the lid and insert the rabble arm.

Place the frozen container into the housing. Then, place the lid with motor onto the

housing and click into place.

Plug in the device. The display shows “20:00”. Using the setting button, select the

desired time. The timer can be set from 20 to 40 minutes.