Steba KH5 - Safe positioning; Use of the heater; Oscillation; Use of the thermostat

10
Safe positioning
∙ The appliance must be used only on a flat, stable surface.
∙ The fan heater only operates when the safety switch on the
bottom of the unit is pressed.
∙ The appliance must be not accessible for persons who are ta-
king a bath or in the shower.
∙ Do not place the cable under a carpet.
∙ Mind that during function the cordset must be always com-
pletely pulled out.
Use of the heater
∙ 1800 W (Oszillation)
∙ 900 W (Oszillation)
∙ OFF
∙ 900 W
∙ 1800 W
Oscillation
:
∙ Due to the oscillation (turning) a more equal temperature in the surrounding is
achieved.
∙ Never block the oscillation movement.
Use of the thermostat
∙ In a room where the temperature is too high (more than 30°C), it is normal that the
thermostat will not switch on the heater.
∙ In a room where the temperature is too low (around 5°C or even less) it is also
normal that the thermostat will keep the appliance working until the temperature
gets higher.
∙ To select the right thermostat position we suggest you to
∙ turn the thermostat in maximum position (clockwise);
∙ leave the appliance working until the comfortable temperature is reached;
∙ turn the knob anti clockwise until you hear a „click“ and the red indication light
turns off;
∙ turn clockwise again the knob (just a little): in this position the thermostat will
maintain the comfortable temperature you have selected. The red indication
light shines if the heater turns on again.
∙ If the appliance is used for the first time there can be a little smoke due to some
production oil residues.
To clean the filter proceed as following (picture)
∙ Pull out the power plug;
∙ Loosen the filter-screw at the back of the product and pull it backwards;
∙ Remove the sponge filter from its holder;
∙ Clean the filter by water with wash power under the temperature of 30°C.