10
Use of the heater
∙ Set the main switch on the rear panel
∙ Press the
button. The display shows the current room temperature.
∙ Press the SET button 1 time. OH flashes in the display. Adjust the time by using the
+/- button in steps of one hour up to 12 hours. Press the SET button again.
∙ 25°C flashes in the display. Adjust the time by using the buttons +/- in steps of 1°C.
∙ By pressing the power button you adjust the power level from low (1300W) to
high (2500W).
∙ Press the SET button, the device works.
∙ If you want to heat without a time-setting, press the SET button twice after setting
the ON/OFF button, regulate the desired temperature and press SET again.
∙ By pressing the button the oscillation starts.
∙ Once the set time has passed the device shuts off or can be shut off by pressing the
button
For cooling, the fan runs for about 15 seconds after the device has been
shut off. Set the main switch.
∙ If the device is used the first time very slight smoke might appear briefly due to pro-
duction residues.
∙ If the appliance is used for the first time there can be a
little smoke due to some production oil residues.
Remote control
You can operate the device, as described above, up to a distance of 7 meters.
Cleaning of the filter
∙ Pull out the power plug;
∙ Press the filter button at the back of the product and pull it backwards;
∙ Remove the sponge filter from its holder;
∙ Clean the filter by water with wash powder under the temperature of 30°C.
Safety in case of abnormal operation
∙ In case of overheating the safety cut out protecting the heating element will auto-
matically switch off the appliance.
∙ In this case the appliance stops working and the pilot light will remain switched on
even if the appliance is not working.
∙ If this happens:
∙ switch off the fan heater;
∙ remove the causes of abnormal operation or overheating (i.e. obstacles in front
of air inlet or air outlet grille);
∙ leave the heater cool down for 15/20 minutes;
∙ switch on again the fan heater.
To Next Page
Loading...