SteelSeries RIVAL 600 - CONFIGURING WEIGHT SYSTEM; Remove the side panels; Choose your desired weights; Re-attach side panels

2s
find help at support.steelseries.com
CONFIGURING WEIGHT SYSTEM
01 Remove the side panels
05
to access the
weight molds
02 Choose your desired weights
12
and insert
them into the dedicated molds
10
03 Re-attach side panels
05
once the desired
weight is calibrated. If you find it not to
your liking, repeat steps 01 to 03
CALIBRATION OF LIFT OFF SENSOR
Your Rival 600 is equipped with a secondary,
high precision lift off sensor. To ensure the
highest level of accuracy, the lift off sensor
must be calibrated to your gaming surface of
choice.
By default your Rival 600 is set to a ~0.5 mm
lift off distance. SteelSeries Engine offers the
ability to further tweak the lift off distance.
Calibration of the lift off sensor can happen in
two ways:
find help at support.steelseries.com
Automatic
On every mouse power up (for instance,
plugging in the USB cable), your lift off sensor
will automatically calibrate.
Manual
If you change gaming surfaces it is
recommended to recalibrate the lift off sensor.
To manually calibrate the lift off sensor, hold
down the CPI button
04
for two seconds to force
recalibration. Your Rival 600 will flash white
three times when lift off calibration is complete.