Steinberg Systems SBS-PW-402C - Common Troubleshooting; Troubleshooting Guide

Trouble Instruction Possible Reason Remedy
AC lamp is not
glowing
Power may
not be con-
nected
• The mains plug may
be disconnected
• The power cable is
damaged
• Insert the power
plug or replace it
if damaged
• Change the pow-
er cable
Scale is not
turning on with
battery
There is no
DC power
supply to the
Scale
• The storage batte-
ry is damaged
• The battery con-
nection are not
proper
• Replace the
battery of the
similar model
• Ensure that con-
nections are in
good condition
Over voltage
LED glows,
Alarms and
automatically
turn off
Over Voltage Battery is in use for too
long time
• Charge the
battery
• Change the
battery is found
damaged
Weight reading
is unstable
Over voltage
or affected by
moisture
Insufcient voltage
OR use of battery is
prolonged even after
the warning alarm OR
too much humidity in
surrounding
Charge the battery
for at least 10 hours;
Or clean the Mother
PCB for drying
Common Trouble Shooting
Following chart will show you the common trouble shooting.
14
EN
INSTRUKCJA OBSŁUGI
WAGI SKLEPOWE
PL