What to do if STEINEL Controller NightMatic 3000 Vario has no power?
If your STEINEL Controller NightMatic 3000 Vario has no power, the fuse may have blown, it might not be switched ON, or a lead could be disconnected. Replace the fuse, switch ON the mains switch, and check the wiring with a voltage tester. Also, check the connections, as a short-circuit may be the cause.
Why does my STEINEL NIGHTMATIC 3000 light fixture not switch ON?
If your STEINEL Controller light fixture does not switch ON, the consumer may be faulty, so change the consumer. Also, check the power supply referring to “NightMatic 3000 Vario without power”. The surroundings might also be too bright; wait until the switching brightness is achieved or set a new switching value using the button.
Why does my STEINEL Controller light fixture switch ON at an unusual time?
If your STEINEL Controller light fixture switches ON at an unusual time, it could be due to the switchover from summer to winter time. Switching times are geared to brightness values, so adjust the setting if required. Alternatively, the switching times may be incorrectly calculated; in this case, readjust the switching value, which will re-determine the switching times.
What to do if STEINEL NIGHTMATIC 3000 light fixture does not switch OFF?
If your STEINEL Controller light fixture does not switch OFF, the surroundings may not yet be sufficiently bright. Wait until sufficient brightness is achieved. If needed, set a new switching value in the evening.
What to do if STEINEL Controller light fixture does not switch ON in the morning?
If your STEINEL Controller light fixture does not switch ON in the morning, the function may not be properly activated. Adjust the function according to the section entitled “Setting for the morning hours”.
Covers device principle, wall mounting, and electrical wiring.
Explains twilight, night economy, and morning hour adjustments.
Addresses power, activation, and timing issues with solutions.
General| IP rating | IP54 |
|---|---|
| Voltage | 230 – 240 V, 50 Hz |
| Light level setting | 2 – 2000 lx |
| Light duration | Not applicable |
| Light sensitivity | Adjustable |
To Next Page
