stelton Brus - User Instructions; CO2 Cartridge Installation; CO2 Cartridge Replacement

3
UK – Brus carbonator
Installation of CO
2
cartridge
1. Remove the seal and protective plug from the CO
2
cartridge.
2. Carefully li your carbonator by the CO
2
cartridge compartment and
turn it upside down so the bottom of the carbonator is visible.
3. Carefully insert the CO
2
cartridge through the hole at the
bottom. Do not drop the cartridge into the hole as this
may cause damage to the internal components.
4. Once the CO
2
cartridge has been inserted into the compartment,
rotate the cartridge clockwise to fasten it. Do this carefully
– no force should be applied to secure the bottle.
5. Now place your carbonator back on the table and it is ready to use.
CO
2
cartridge replacement
1. Carefully li your carbonator by the CO
2
cartridge compartment and
turn it upside down so the bottom of the carbonator is visible.
2. Turn the CO
2
cartridge counterclockwise to release it.
3. Once released, pull out the empty CO
2
cartridge and follow the
"Installation of CO
2
cartridge" instructions to insert a new cartridge.
IMPORTANT: A CO
2
cartridge is not included in
the gibox. These can be purchased in leading
supermarkets and department stores.
425 g
Ø 60 mm
CO
2
User instructions
Before using your Brus carbonator for the rst time, please
read the user and safety instructions in this manual.