60
UK
The steel jug can be placed on the base from all angles.
Keep the cord as short as possible. Any excess cord
should be rolled up under the base.
IMPORTANT: Before lling the kettle with water, remove
from base. Only ll up to the steel jug’s MAX mark on 1.2 L
(see image 2) and push the lid rmly in place.
WARNING: If the electric kettle is lled above the MAX
mark see image 2), boiling water may spray out of the
kettle when in use.
The rstrsttime the electric kettle is used, water should
be boiled three times in the kettle before drinking. This
ensures that any minor impurities from production are
removed.
The electric kettle is switched on using the on/o switch
under the handle (see image 2).
When the water boils (100 °C), the electric kettle auto-
matically switches o and the light goes o. To boil more
water, the switch needs to be switched on again. The
automatic dry-boil protection prevents accidental boiling
when the steel jug is placed back on the base aer pour-
ing. Always unplug when the kettle is not in use.
IMPORTANT: Always check the lid is securely in place be-
fore switching the kettle on. The lid will click when pressed
into place. If the lid is not clicked into place, the kettle’s
automatic dry-boil protection will not work optimally. The
kettle must not be used without a lid as there is a risk of
boiling water spraying out. Should any irregularities occur
with the dry-boil protection, such as the kettle switching
o before reaching 100 °C or aer, leave the kettle to
cool; see section on maintenance.
Dry-boil protection
The electric kettle has an inbuilt dry-boil protection,
which means the heat element disconnects automati-
cally if the kettle has limescale, if it is switched on without
water in it, or if it boils dry. Should this happen, check
whether there is a build-up of limescale at the bottom of
the kettle and then descale as required. Test the kettle
by lling with water and plugging the apparatus in. If the
electric kettle continues to disconnect before boiling
point, take the kettle and base to the dealer you bought
it from for an inspection.
Maintenance
Descaling the lter
The electric kettle is supplied with a removable limescale
lter, which is placed in the spout. The lter prevents limes-
cale sediment in the water from pouring into the cup. It
is important to clean the limescale lter before too much
limescale builds up as otherwise the water cannot pass
through the lter and will instead pour out along the sides
of the lid, which increases the risk of scolding.
The lter is easily removed from the steel jug by pulling it
upwards. Any limescale on the lter can be brushed o
under running water with a washing-up brush or cloth.
Alternatively soak the lter in household vinegar or des-
caling uid. Aer cleaning with clean water, secure the
lter back in its place.
Cleaning the jug
Wipe the outside of the jug with water and detergent us-
ing a so, damp cloth. Dry using a so cloth or tea towel.
Never use scouring powder or other cleaning agents with
an abrasive eect, as this will scratch the surface.
Descaling the kettle
The electric kettle must be descaled regularly and
cleaned from limescale sediment:
Normal maintenance. Check weekly that the kettle
does not have a limescale build-up. We recommend
only boiling as much water as is needed. You then avoid
water being le in the kettle, which increases the amount
of limescale sediment. You also save electricity.
Descale as required. Use one of the following methods:
· Method 1: To remove mild limescale sediment, once a
week ll with clear household vinegar until it covers the
bottom of the steel jug. Leave the steel jug for a couple
of hours, empty and rinse well. Tip: the descaling pro-
cess is accelerated by heating the liquid to 50–60 °C.
· Method 2: To remove tough limescale sediment, ll
with 0.25 L clear household vinegar and 0.75 L water.
Switch on the kettle and let it boil. Leave it to cool for 15
minutes, then boil again twice.
Once cleaned, boil water in the kettle another three
times before drinking. This ensures that any remnants of
the descaling liquid are removed from the kettle.
If limescale still remains aer descaling, make sure the
kettle is descaled more frequently.
IMPORTANT: Only use descaling uid and household
vinegar to descale the kettle. Never use sharp objects
to clean or descale the heat plate at the bottom of the
steel jug. If the jug is not descaled regularly, it can lead
to the heat element or the jug becoming damaged. This
type of damage is not covered by the guarantee.
SAFETY
Read the instructions thoroughly before use and store
them for later use.
Connect the Emma electric kettle to 220–240 V and only
use the kettle for boiling water.
The electric kettle is for household use only, not commer-
cial use (e.g. in an industrial kitchen). Should the kettle
be used for other purposes, or should the kettle not be
used in accordance with the instructions, the user shall
bear full responsibility for any consequences. The right to
complain as a result shall not cover any damage to the
kettle or personal injury.
Always use the kettle under supervision.
Instructions
To Next Page
Loading...
