To Next PageTo Next Page
Need help?Do you have a question about the Step 2 SAFARI TRUCK CLIMBER and is the answer not in the manual?
General| Brand | Step 2 |
|---|---|
| Model | SAFARI TRUCK CLIMBER |
| Category | Play Sets & Playground Equipment |
| Language | English |
Small parts and sharp points. Adult assembly required.
Check product temperature before use. May cause burns if left in direct sunlight.
Do not attach loose hanging items. Avoid clothing with drawstrings or cords.
Falls to a hard surface can result in serious injury or death.
Instruct children on safe use. Always supervise children to ensure safe product use.
Create an obstacle-free site and choose a level location.
Maintain minimum fall height and use appropriate surfacing material.
Provide adult supervision, limit children, and dress appropriately.
Instruct children to slide feet first and remove hazardous items.
Do not use equipment in unintended ways or when temperatures are extreme.
Inspect product for loose or damaged components and tighten connections.
Use a 50/50 mixture of white vinegar and water for cleaning.
Disassemble product to prevent hazards and recycle when possible.
Information on minimum loose-fill surfacing depths for fall protection.
Ensure a gap of less than 3/16" when tightening bolts for safety.
List of screws and washers for Set A.
List of screws and washers for Set B.
List of screws, nuts, and washers for Set C.
Steps for attaching handles to the main body using screws.
Repeat handle attachment steps for other sides.
Attaching wheel components to the main body.
Attaching support arms to the main body.
Repeat steps to attach components to the other side.
Attaching interior side panels.
Attaching the dashboard to the main cabin.
Securing interior panels with screws.
Attaching the floor section to the base.
Installing the control module into the dashboard.
Attaching the steering wheel to the control module.
Attaching the door panels to the cabin.
Attaching the remaining door panels.
Installing the dashboard assembly into the cabin.
Attaching the roof section to the cabin.
Securing the roof section with screws.
Attaching the front bumper support piece.
Assembling and installing the binoculars mount.
Attaching the binoculars to the mount.
Attaching the seat bases to the main body.
Attaching the slide to the main body.
Securing the slide with screws.
Installing the large wheels onto the axles at a 45° angle.
Guide for applying decals to the truck body and slide.
