179
Operate the product : illustration
4.1
to
4.5
It is recommended to use a rope attached to the handle to install the pump at the bottom of the water.
the pump.
Make sure that the pump is installed upright and stable on the bottom of the water.
start automatically.
Plug in the electrical outlet.
Note : The pump will start automatically after plugging the
cable outlet.
• Operate the product only at reasonable hours – not early in the
morning or late at night when people might be disturbed.
• Do not modify the product in any way or use parts and
accessories that are not recommended by the manufacturer.
vibrate abnormally, immediately stop the product and
inspect for damage or identify the cause of the vibration. Any
damage should be properly repaired or replace by an
authorized service center.
Stop the pump
•
• To reduce the risk of injury, always stop the machine :
- before cleaning or clearing a blockage
- when leaving the product unattended
- before installing or removing attachments
- before checking, maintaining or working on the product
- if the machine starts to vibrate abnormally (inspect
immediately)
.
4.5 SPECIFIC FUNCTIONS
45
To Next Page
Loading...
