228
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
BR
EN
pull the lower tube until the button is disengaged then release it.
Installing/Removing the battery pack
WARNING : Make sure the latch on the bottom of the battery pack snaps in place and the battery pack is
fully seated and secure in the blower’s battery docking port before beginning operation.
Failure to securely seat the battery pack could cause the battery pack to fall out, resulting in serious
personal injury.
To install : To attach, align and slide the battery pack onto the slots of the battery docking port until it
locks in place.
To remove : To release, press the battery unlock button and remove the battery pack from the product.
4.3 FIRST USE
Check the battery
WARNING ! Read the « SAFETY INSTRUCTION » section at the
beginning of this manual including all text under subheading
therein before using this product.
The battery is not fully charged at the time of purchase.
Before using the blower for the rst time, place the battery in
the charger and charge it fully.
Pay particular attention using the machine for the rst time : focus and dedicate all your attention to this
rst use. Make the rst trial on a free space with no obstacle and no surrounding element
4.4 OPERATION
Start the product
To start the blower, press the switch button to 1 or 2. To stop, press the button to 0. There are two speed
buttons on top of the 20V blower. The bottom button moves the blower into HIGH SPEED (183km/h). The
top button moves the blower into TURBO SPEED (200km/h).
Operate the product
CAUTION ! Always wear safety glasses. Wear a lter mask if
the operation is dusty. Use of proper gloves and substantial
footwear is also recommended.
• Operate the product only at reasonable hours – not early in the morning or late at night
when people might be disturbed.
• Do not operate the product in an explosive atmosphere.
• Avoid using the product in bad weather conditions, especially when there is a risk of
lightning. Do not operate the product in poor lighting. The operator requires a clear view
of the work area to identify potential hazards.