STERWINS 40VLM2-42P.1 - End of Life

296
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
Problems Probable causes Solutions
Qualication
required
The mower
vibrates at high
speed
The blade is out of balance
or worn
Change the blade -
The motor shaft is twisted
Turn o the motor and inspect
the mower. Get the mower
repaired.
The motor stops
while mowing
The cutting height is too
low
Raise the cutting height
-
The battery is discharged Recharge the battery
Mower suddenly
stopped while
cutting grass.
Mower maybe occur
overload
Stop the mower and wait for 3
minutes to restart.
Product does
not reach full
power
Battery pack capacity too
low
Charge battery pack
-
Air vents are blocked Clean the air vents
Vibration
or noise is
excessive
Bolts/nuts are loose Tighten bolts/nuts -
Product
suddenly stops
Battery pack discharged
Remove and charge battery
pack
-
Battery too hot
Remove battery pack and let it
cool down
8.5 FATAL CIRCUMSTANCES : CRITICAL ISSUES
Problems Solutions
The machine starts to smoke
Stop immediately the machine and bring it to
repair center.
The machine starts to vibrate abnormally
Stop the machine, remove the safety key and
check immediately for the cause. check the state
of the blade. High vibration is generally a warning
of trouble, if no root cause is found, bring the
mower to the repair center.
9. END OF LIFE
Electrical products should not be discarded with household products. Used electrical products
must be collected separately and disposed of at collection points provided for this purpose.
Talk with your local authorities or dealer for advice on recycling.