STERWINS EHT2-60.4 - Assembly; Unboxing; Installation; Preparation

183
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
The declared vibration and noise total value has been measured in accordance with a
standard test method and may be used for comparing one tool with another. The declared
vibration total value may also be used in a preliminary exposure assessment. The vibration
emission and noise during actual use of the power tool can dier from the declared total value
depending on the ways in which the tool is used; and it may be necessary to identify safety
measures to protect the operator that are based on an estimation of exposure in the actual
conditions of use (taking into account all parts of the operating cycle such as the times when
the tool is switched o and when it is running idle in addition to the trigger time).
3. ASSEMBLY
WARNING! THE PRODUCT MUST BE FULLY ASSEMBLED BEFORE
OPERATION! DO NOT USE A PRODUCT THAT IS ONLY PARTLY
ASSEMBLED OR ASSEMBLED WITH DAMAGED PARTS! FOLLOW
THE ASSEMBLY INSTRUCTIONS STEP-BY-STEP AND USE THE
PICTURES PROVIDED AS A VISUAL GUIDE TO EASILY ASSEMBLE
THE PRODUCT !
3.1 UNBOXING
9
5
1
2
4
6
7
10
3
8
1. Front handle
2. Hand safety switch
3. Switch trigger
4. Rear handle
5. Guard
6. Cable strain relief
7. Opening
8. Blade
9. Blade cover
10. LED Indicator
• WEAR GLOVES WHEN UNBOXING.
• DO NOT USE CUTTER, KNIFE, SAW OR ANY OTHER SIMILAR TOOL FOR
UNBOXING.
• CARRY THE TOOL ONLY BY THE HANDLE (4 & 1). KEEP THE BOX FOR
FURTHER REUSE (TRANSPORT AND STORAGE).
• KEEP INSTRUCTION MANUAL IN A DRY AREA FOR FURTHER CONSULTATION.
3.2 INSTALLATION
Install the front handle : illustration
2.1
and
2.2
Align and push the handle in the space provided for this purpose. Put the screw with a
screwdriver. Tighten the screws securely.
3.3 PREPARATION
Blade cover : illustration
3.1
Remove the blade cover from the blade before operation. Align and push the blade cover onto
the blade to attach it.