5.TROUBLESHOOTING
Problem Possible cause Solution
Product does not start • Not connected to power supply
• Power cord or plug is defective
• Other electrical defect to the
product
• Overload protection is activated
• The blade guard is not xed
properly.
• Connect to power supply
• Check by a specialist
electrician
• Check by a specialist
electrician
• Wait until the product cools
down and press the “ON”
button.
• Fix the guard correctly
Shredding material is not cut
cleanly
• Counter blade is not properly
adjusted
• Adjust the counter blade
Excessive vibration or noise • Blade is damaged
• Blade blocked
• Bolts/knobs are loose
• Have the blade replaced by
a certied agent
• Remove the blockage
• Tighten the bolts/knobs
196
EN
To Next Page
Loading...
