2. SAFETY INSTRUCTIONS
EN
Handling fuel
esool a – gulp kraps eht no detnuom yleruces si toob gulp kraps eht taht kcehC •
01 tsael ta enigne eht tratS • feet (3m) from the fueling spot, outdoors only.
taht erus yletulosba eb ,tcatnoc enil ro edalb morf yrujni fo ksir eht ecuder oT •
the cutting attachment is clear of you and all other obstructions and objects,
including the ground, because when the engine starts at starting-throttle,
engine speed will be fast enough for the clutch to engage and move the cutting
attachment.
.dnah ruoy dnuora epor retrats eht parw ton od ,pirg retrats eht llup uoy nehW •
Do not let the grip snap back, but guide the starter rope to rewind it properly.
may damage the starter mechanism.
enihcam sihT • is equipped with a clutch. Regularly check that the cutting
attachment should stop when the engine running at idle speed. If the cutting
attachment rotates at idle speed, contact with the local dealer for checking and
repair.
• This unit is equipped with a switch by push it towards «STOP», «O» side the
engine can be brought to a nal stop.
Note: Always stop the engine before doing any work on the cutting
attachment.
elcyc-2 delooc-ria rof detalumrof yllaiceps lio yb detacirbul era senigne ehT •
gasoline engine use. If oil is not available, use an antioxidant added quality oil
expressly labeled for air-cooled 2-cycle engine use.
1 LIO : 04 ENILOSAG :OITAR GNIXIM DEDNEMMOCER
diova dna niks eht htiw tcatnoc tcerid diovA .enilosag gnildnah nehw erac ekaT •
inhaling fuel vapour.
98 fo gnitar enatco muminim a htiw enilosag dedaelnu edarg-dim esU •
((R+M)/2).
249
To Next Page
Loading...
