EasyManua.ls Logo

STERWINS UP20 - Preparation; First Use; Operation

STERWINS UP20
228 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
205
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
4.3 PREPARATION
Installing/Removing the battery pack: illustration
3.1
WARNING: Make sure the latch on the bottom of the battery pack snaps in place and the
battery pack is fully seated and secure in the product’s battery docking port before beginning
operation. Failure to securely seat the battery pack could cause the battery pack to fall out,
resulting in serious personal injury.
To install: To attach, align and slide the battery pack onto the slots of the battery docking port
until it locks in place.
To remove: To release, press the battery unlock button and remove the battery pack from the
product.
Wear safety equipement: illustration
3.2
Before using the product, make sure to put on the following protective equipement :
Safety glasses
Face mask
Use of chainsaw jackets
Earmus
Protective gloves
Protective overall
Safety boots
4.4 FIRST USE
WARNING ! READ THE « SAFETY INSTRUCTION » SECTION AT THE
BEGINNING OF THIS MANUAL INCLUDING ALL TEXT UNDER
SUBHEADING THEREIN BEFORE USING THIS PRODUCT.
Note: The battery is not fully charged at the time of purchase. Before using the product for the
first time, place the battery in the charger and charge it fully.
Pay particular attention using the machine for the first time : focus and dedicate all your
attention to this first use. Make the first trial on a free space with no obstacle and no surrounding
element.
4.5 OPERATION
WARNING ! THE PRODUCT CAN ONLY BE USED OUTDOORS, AND IN
NO CASE IN A BUILDING. THE PRODUCT MUST BE LEFT OUTDOORS
FOR AT LEAST TWO HOURS BEFORE ENTERING INSIDE A BUILDING.
Start the product: illustration
4.1
to
4.4
To turn the tool ON, push and hold the safety lock-o button with your thumb, while squeezing
the ON/OFF trigger switch. Once the trigger switch engages, you can release the safety lock-o
button and proceed with operation. The safety lock-o button reduces the risk of accidental
starting. To turn the tool OFF, release the ON/OFF trigger switch.
CAUTION ! ALWAYS WEAR SAFETY GLASSES, SUBSTANTIAL
FOOTWEAR AND LONG TROUSERS. WEAR A FILTER MASK IF
THE OPERATION IS DUSTY. USE OF PROPER GLOVES IS ALSO
RECOMMENDED.

Table of Contents