STIEBEL ELTRON CWM 500 P - 9 Appliance Description; 10 Installation; Installation Site; Installing the Wall Mounting Bracket

INSTALLATION
Appliance description
ENGLISH
www.stiebel-eltron.com CWM P | CWM U | 9
9. Appliance description
9.1 Standard delivery
The following are delivered with the appliance:
- Wall mounting bracket (hooked into the appliance)
10. Installation
10.1 Installation site
Installation in bathrooms
WARNING Electrocution
When installing the appliance in rooms with a bath and/
or shower, the appliance may only be connected to a
standard socket outside safety zones 0, 1 and 2. The
socket must be at least 600mm away from a bath or
shower. If in doubt, consult a qualified contractor.
600
600
2250
1
2
3
0
D0000097137
Electrical safety zones in the bathroom
10.2 Minimum clearances
≥150≥100
≥100 ≥100 ≥500
≥20
D0000068096
10.3 Installing the wall mounting bracket
The appliance is intended for wall mounting using the wall mount-
ing bracket supplied. The appliance may only be installed hori-
zontally.
Note
- The wall mounting bracket can be used as a tem-
plate for wall mounting. This ensures sufficient
clearance from the floor.
- Use a spirit level if the floor is uneven or sloping.
aaa
D0000072159
1
3
2
4
≥224 ≥224
D0000072312
f Unhook the wall mounting bracket from the appliance.
f Place the centred wall mounting bracket horizontally on the
floor. Mark holes1 and 2.
f Lift up the wall mounting bracket so that its lower holes
match up with the markings you have just made on the in-
stallation wall.
f Mark holes3 and 4 on the installation wall.
f Drill the holes at the 4markings.
f Secure the wall mounting bracket with suitable fixing ma-
terials (screws, rawl plugs). With the vertical slots, you can
compensate for an offset fixing hole.