www.stiebel-eltron.com DHM | 41
ENGLISH
INSTALLATION
Maintenance
14. Maintenance
DANGER Electrocution
Before any work on the appliance, disconnect all poles
from the power supply.
Draining the appliance
DANGER Scalding
Hot water may escape during the draining process.
If the appliance needs to be drained for maintenance or to protect
the whole installation when there is a risk of frost, proceed as
follows:
Close the shut-off valve in the cold water inlet line.
Open the draw-off valve.
Undo the water connections on the appliance.
Cleaning the strainer
You can clean the fitted strainer after removing the cold water
supply pipe.
26�02�05�0065�
Checking the earth conductor
Check the earth conductor (in Germany e.g. BGV A3) on the
earth conductor contact of the power cable and on the appli-
ance connector.
Appliance storage
Store the dismantled appliance in a room free from the risk
of frost, as water residues remaining inside the appliance can
freeze and cause damage.
Replacing the power cable for the DHM 6
If replacing the cable for the DHM6, use a power cable with
4mm² cross-section
To Next Page
Loading...
