STIEBEL ELTRON HDB-E 11/13 Trend - Water Installation on Finished Walls with Solder;Press Fittings; Fitting Appliance Cover for Water Installation on Finished Walls; Lower Back Panel Section Installation with Threaded Fittings on Finished Walls; Wall Mounting Bracket When Replacing an Appliance

INSTALLATION
Installation alternatives
13.6 Water installation on finished walls with
solder/press fittings
0111
Notice
This type of connection changes the IP rating of the ap-
pliance.
> Change the type plate. Cross out " IP 25" and mark
the box " IP 24". Use a ballpoint pen to do this.
You can connect copper or plastic pipes with the accessories " sol-
der fitting" or " press fitting".
With " solder fitting" with threaded fitting for 12 mm copper pipes,
proceed as follows:
> Push the union nuts over the connection pipes.
> Solder the inserts to the copper pipes.
> Push the lower back panel section under the connection
pipes of the tap and push it into the back panel.
> Secure the connection pipes to the tee and the 3- way ball
shut-off valve.
Notice
Observe the tap manufacturer's instructions.
13.7 Fitting appliance cover for water installation on
finished walls
1 Back panel guides
2 Screw
3 Cover guides with sealing lips on the pipe side
4 Pipe knock-out
> Cleanly saw and break out the pipe knock-outs in the appli-
ance cover. If necessary, use a file.
> Click the cover guides into place in the knock-outs.
Only if using the " solder fitting" accessory and with precise
adherence to all installation dimensions:
> Break the sealing lips out of the cover guides.
> Position the back panel guides on the pipes. Push them to-
gether. Then push the guides against the back panel as far
they will go.
> Secure the lower back panel section with a screw.
In
Notice
You can use the cover guides with sealing lips to com-
pensate for a slight offset of the connection pipes and/
or if using the " press fitting" accessory. In this case, the
back panel guides are not fitted.
13.8 Lower back panel section installation with
threaded fittings on finished walls
1 Lower back panel section
2 Connection piece in the standard delivery
3 Screw
If using threaded fittings on finished walls, the lower back panel
section can also be installed after fitting the taps. To do this, carry
out the following steps:
> Cut open the lower back panel section.
> Fit the lower back panel section by bending it out at the sides
and guiding it over the pipes.
> Insert the connection pieces into the lower back panel sec-
tion from behind.
> Click the lower back panel section into place.
> Secure the lower back panel section with a screw.
13.9 Wall mounting bracket when replacing an
appliance
An existing STIEBEL ELTRON wall mounting bracket may be used
when replacing appliances ( except the DHF instantaneous water
heater), as long as the fixing screw is in the lower right position.
Replacing a DHF instantaneous water heater
> Reposition the fixing screw on the wall mounting bracket ( the
fixing screw has a self- tapping thread).
> Rotate the wall mounting bracket 180° and mount it on the
wall ( the DHF logo is then turned towards you).
www.stiebel-eltron.com HDB-E Trend I 35