STIEBEL ELTRON HPG-I 04 S Premium - Page 34

Repair instructions
HPG-I 04-06-08-12-15 S-CS-DS-DCS
Premium
TQR
Page 34 from 48
D0000095883-c
Message code
Reason for the message
Possible remedy
2-0140
Inverter main fault: Motor current
offset.
Inverter error
2-0141
Inverter main fault: PFC current offset.
Inverter error
2-0142
Inverter main error: Measurement of
motor inductance.
Inverter error
2-0143
Inverter main fault: Motor phase
resistance.
Inverter error
2-0144
Inverter main fault: Restart
Inverter error
2-0145
Inverter main fault: Motor overcurrent
shutdown function.
Inverter error
2-0146
Inverter main fault: IGBT US short
circuit.
Inverter error
2-0147
Inverter main fault: IGBT OS short
circuit.
Inverter error
2-0148
Inverter main fault: Motor phase short
circuit.
Inverter error
2-0149
Inverter main error: SVM function
Inverter error
2-0232
Inverter main fault: PFC overcurrent
shutdown function.
Inverter error
2-0233
Inverter secondary fault: Inverter
temperature control.
Inverter error
2-0234
Inverter secondary fault: Input current
control.
Inverter error
2-0235
Inverter main fault: High pressure sensor
underrange.
Inverter error
2-0236
Inverter main fault: Compressor type
configuration.
Inverter error
2-0237
Inverter main fault: High pressure sensor
configuration.
Inverter error
2-0241
WPM update carried out
Information
2-0242
FES update carried out
Information
2-0243
FET update carried out
Information
2-0244
WPM update failed
Start update again
2-0245
FES update failed
Start update again
2-0246
FET update failed
Start update again
3-0007
Insufficient pressure in the heat source
circuit.
Check heat source for pressure
maintenance. OFF 0.5 bar ON 1.0 bar
3-0008
Switch WP type of the IWS is not set
correctly.
Switch off the mains voltage of the heat
pump and set the switch correctly.
3-0010
Sensor value of "FE7" outside the
permissible value range
Check the sensor, its wiring and the
associated connectors, replace if defective.
Terminal: WPM X1.13
3-0011
Version conflict FES
The FES needs a software update. Have
an update carried out.
3-0012
Version conflict WPE
The WPE needs a software update. Carry
out the update.
3-0013
Version conflict FET
The FET needs a software update. Carry
out the update.
3-0014
Version conflict WPM
The WPM needs a software update. Carry
out the update.
3-0016
Sensor value of the hot gas temperature
sensor outside the permissible value
range.
Check the sensor, its wiring and the
associated connectors, replace if defective.