10
Heating programs
In parameter HTG PROGS, you can adjust the
heating programs for Heating circuit 1 and 2.
You can adjust your heating system as follows:
– for every day of the week
(Monday, ..., Sunday)
– Monday to Friday (Mo - Fr)
– Saturday and Sunday (Sa - Su)
– the whole week (Mo - Su)
You can adjust three switching time pairs
(I, II, III) for each of these options.
This determines when and how often the
ventilation system should heat in day mode.
At all other times, the ventilation equipment
operates in setback mode. You will already
have selected the corresponding set values for
day and setback mode under parameter ROOM
TEMP 1/2.
Example:
For heating circuit 1, your heating system
should operate daily from Monday to Friday
at two different times, i.e. from 05:30 h until
08:30 h as well as from 14:00 h until 22:00 h.
For the weekend, your heating system should
provide heat from 08:30 h until 21:00 h.
Open the control flap.
Heat circuit 1
or
Heating circuit 2
HTG PROG
HEAT CIRCUIT 1
MON - FRI
HEATING START
HEATING STOP
SAT - SUN
BACK
BACK
HTG PROG
HEATING START
HEATING STOP
HEATING START
HEATING STOP
HEATING START
HEATING START
HEATING START
SAT - SUN
To Next Page
Loading...
